Hey! Converting python code to curl can be a bit tricky at first, but it’s not too bad once you get the hang of it. For headers, you can just use the `-H` flag in curl and paste them as-is. For params, use `-d` or `--data-urlencode` depending on the type.
If you’re using `requests`, you can actually print out the equivalent curl command using the `requests-toolbelt` library. It’s super handy! Just install it and use `curlify` to auto-generate the curl command.
Also, check out https://curlconverter.com/ – it’s a lifesaver for stuff like this. Paste your Python code, and it spits out the curl command.
Hope that helps!
If you’re using `requests`, you can actually print out the equivalent curl command using the `requests-toolbelt` library. It’s super handy! Just install it and use `curlify` to auto-generate the curl command.
Also, check out https://curlconverter.com/ – it’s a lifesaver for stuff like this. Paste your Python code, and it spits out the curl command.
Hope that helps!