Hey everyone,
I’m kinda stuck here and need some help. So, what should the customer do to change static command? I’ve been trying to figure it out for a while now, but no luck.
I’ve checked the settings, but it’s not super clear. Do I need to reset something? Or is there a specific step I’m missing?
Also, if anyone’s done this before, could you share how you did it? Like, what should the customer do to change static command without messing things up?
Thanks in advance! You guys are always super helpful.
P.S. Sorry if this is a dumb question, I’m still learning all this stuff lol.
I’m kinda stuck here and need some help. So, what should the customer do to change static command? I’ve been trying to figure it out for a while now, but no luck.
I’ve checked the settings, but it’s not super clear. Do I need to reset something? Or is there a specific step I’m missing?
Also, if anyone’s done this before, could you share how you did it? Like, what should the customer do to change static command without messing things up?
Thanks in advance! You guys are always super helpful.
P.S. Sorry if this is a dumb question, I’m still learning all this stuff lol.