Hey there! I’ve been using card scrapers for years, and my go-to method is burnishing with a hardened steel rod. It’s super consistent once you get the hang of it.
I also use a honing guide to keep the angle steady—makes a huge difference. As for frequency, I sharpen mine every 2-3 projects, but it really depends on how much you’re using them.
If you’re looking for a quick method, check out the Veritas Burnisher. It’s a bit pricey but worth it for the results.
I also use a honing guide to keep the angle steady—makes a huge difference. As for frequency, I sharpen mine every 2-3 projects, but it really depends on how much you’re using them.
If you’re looking for a quick method, check out the Veritas Burnisher. It’s a bit pricey but worth it for the results.