+- Proxy Community (https://proxycommunity.com/forum)
+-- Forum: Proxy Types (https://proxycommunity.com/forum/forum-proxy-types)
+--- Forum: Residential Proxies - Rotating Residential Proxies (https://proxycommunity.com/forum/forum-residential-proxies-rotating-residential-proxies)
+--- Thread: How Do You Set Up a Linux Curl Proxy for Your Requests? (/thread-how-do-you-set-up-a-linux-curl-proxy-for-your-requests)
How Do You Set Up a Linux Curl Proxy for Your Requests? - CipherGlide77 - 16-01-2025
Hey everyone!
I’m trying to figure out how to set up a linux curl proxy for my requests and could really use some guidance.
I know that curl is a powerful tool, but I’m not exactly sure how to configure it to route through a proxy.
Do I just add some flags to the command line?
Are there different options for HTTP vs. HTTPS proxies that I should be aware of?
Also, if anyone has tips on testing the setup to make sure it’s working correctly, that would be super helpful!
Thanks in advance for your help! 😊
RE: How Do You Set Up a Linux Curl Proxy for Your Requests? - CipherGlide77 - 19-01-2025
Thanks for all the helpful tips, everyone!
I’m going to try that test with `ifconfig.me` to see if my linux curl proxy is working properly.
If I run into any issues, I’ll be back with questions! 😊
RE: How Do You Set Up a Linux Curl Proxy for Your Requests? - Ozito777 - 24-01-2025
I usually set up my linux curl proxy and then run a few tests with different URLs.
If it works for HTTP but not HTTPS, double-check your proxy settings.
Some proxies only support one type!
RE: How Do You Set Up a Linux Curl Proxy for Your Requests? - proxySprint99 - 03-02-2025
To check if your linux curl proxy is working, you can do a request against a service that shows your IP, like `http://ifconfig.me`.
Just run `curl -x http://yourproxy:port http://ifconfig.me` and see if the IP matches your proxy's.
RE: How Do You Set Up a Linux Curl Proxy for Your Requests? - SafeRoute7 - 05-02-2025
Setting up a linux curl proxy is pretty straightforward!
You just need to use the `-x` or `--proxy` flag followed by your proxy address.
For example: `curl -x http://yourproxy:port http://example.com`.
Make sure to specify if it’s HTTP or HTTPS!
RE: How Do You Set Up a Linux Curl Proxy for Your Requests? - shadowSprintX - 11-02-2025
If you’re using a SOCKS proxy, you can specify it with `curl` too by using the `socks5://` scheme.
Just remember to adjust your command accordingly.
Good luck with your linux curl proxy setup!
RE: How Do You Set Up a Linux Curl Proxy for Your Requests? - deepNomad99 - 15-02-2025
Yeah, definitely use the `-x` option for your linux curl proxy setup.
For HTTPS, you might need to use the `--proxy-insecure` flag if your proxy has issues with SSL verification.
It’s a good idea to test it with a simple request first to see if it’s working!